Products and Technologies for Embedded Systems and Networking
2006-02-07
Turnkey Embedded System: ANAHEIM WiFi
Serial to WiFi bridge.
Description
Available either with power and serial connectors + fixing holes (depending onthe models) for a stand-alone use or with a pin strip connector in order to plug the module over a host board.
Configuration is achieved via web server if the communication with an AP is set with no problems. As an alternative, user can configure Anaheim Wi-Fi via RS232 link. Program is downloadable from this site (see below).
Anaheim Wi-Fi works in two main modes, both of them are selectable in the configuration menu. First mode is the most conventional one. In this mode an equipment with RS232 (or RS485, or UART) enters into a LAN network without the need of a LAN cable. To do so, a commercial Access Point must be available.
In the so called "ad-hoc" mode, two Anaheim Wi-Fi modules are able to set a point-to-point link. In this mode two equipment with RS232 (or RS485, or UART) are able to link in a wireless fashion, avoiding therefore the use of a cable between them.
Technical characteristics:
Processor: Ubicom IP2022
Models and order codes:
Prices:
samples: 109,00 Euro;
100+ : 95,00 Euro;
Wi-Fi module is always included
Documentation:
Anaheim WiFi product brief: AnaheimWiFi-pb.pdf
Software and technical documentation:
The following zipped files provides the Anaheim WiFi Configuration Program and the User's Manual. Anaheim WiFi Configuration Program 1.2.1 and User's Guide 0.9.3: DAWK-0.9.3.zip
Available either with power and serial connectors + fixing holes (depending onthe models) for a stand-alone use or with a pin strip connector in order to plug the module over a host board.
Configuration is achieved via web server if the communication with an AP is set with no problems. As an alternative, user can configure Anaheim Wi-Fi via RS232 link. Program is downloadable from this site (see below).
Anaheim Wi-Fi works in two main modes, both of them are selectable in the configuration menu. First mode is the most conventional one. In this mode an equipment with RS232 (or RS485, or UART) enters into a LAN network without the need of a LAN cable. To do so, a commercial Access Point must be available.
In the so called "ad-hoc" mode, two Anaheim Wi-Fi modules are able to set a point-to-point link. In this mode two equipment with RS232 (or RS485, or UART) are able to link in a wireless fashion, avoiding therefore the use of a cable between them.
Technical characteristics:
Processor: Ubicom IP2022
Models and order codes:
- DAW 11 : DB9 connector for RS232 signals and MSTBA for power
- DAW 12 : MSTBA connector for RS485 signals and MSTBA for power
- DAW 23 : low-voltage UART signals and pin-strip connector
- DAW 24 : low-voltage Rx-Tx-Dir signals and pin-strip connector
Prices:
samples: 109,00 Euro;
100+ : 95,00 Euro;
Wi-Fi module is always included
Documentation:
Anaheim WiFi product brief: AnaheimWiFi-pb.pdf
Software and technical documentation:
The following zipped files provides the Anaheim WiFi Configuration Program and the User's Manual. Anaheim WiFi Configuration Program 1.2.1 and User's Guide 0.9.3: DAWK-0.9.3.zip
